Jump to content

- - - - -

out of control

turn a320 climb airbus

  • This topic is locked This topic is locked
2 replies to this topic

#1 alanbyrne


    New Member

  • Members
  • Pip
  • 4 posts
  • Country:Ireland

Posted 15 July 2013 - 12:16 PM

hi all,, I am new to airsimmers a320 flown wilco for a while.. however I started a flight today from LEAL to EIDW I calculated my fuel etc and began the flight after I took off I started to climb out and fly my route after 30,000ft I noticed the aircraft rate of climb was just at 300ft a min and seemed to be struggling to gain altitude I was climbing to 390ft,, so I engaged vertical speed and manually entered 1000ft to see how it would climb all seemed well until I came to a 60 degree turn and as the aircraft turned it seemed fine but when It came to levelling the wings it began to drop the left wing then the right and then the left again it was all over the place I had to disengage the ap and manually control it back to level after a lot of effort the wings levelled,,, any ideas why ????????

#2 mpurps


    Established Member

  • Members
  • PipPip
  • 21 posts
  • Country:Germany

Posted 17 July 2013 - 08:13 PM

High Alan,

this bug occurs in both, the IAE and the CFM model. I have not found any fix for this, a workaround is to switch off some of the sec (1 and 3(?)) in the overhead to limit the effect. I have always problems with the spoilers, first with the IAE only but recently also with the CFM model, following those oscillations.


#3 AAA578



  • Customer Support
  • PipPipPipPipPip
  • 857 posts
  • Gender:Male
  • Location:YPPH
  • Country:Australia

Posted 22 July 2013 - 09:14 AM

Hi please register your product with the forums the link is at the top left of the page


Technical support will only be given in the technical support forums, and your question may have already been answered.
Posted Image
Windows 7 64bit Asus P8P67 Pro Intel Core i5-2500K 3.30Ghz ASUS GTX550 Ti 1GB GDDR5 @ 910MHz 8GB DDR3 RAM